PA Mud Sucker tool bare 
Requires 1/4 inch NPT(M) zero degree WashJet nozzle
3/8 inch BSP(F) inlet
1-1/4 inch BSP(F) outlet 
250 bar (3650 psi) rated
25 lpm max input flow
90 degrees C max rated temperature
Note: 
Only use zero degree WashJet nozzle (not included)
How does the PA Mud Sucker work?
Pressure from a water blaster (pressure washer) is fed into the 3/8 inch BSP(F) inlet port
This water pressure is channeled around to spray vertically
It is forced through a zero degree stainless steel WashJet nozzle
This water flow in turn creates a venturi effect, drawing up any mud, solids and stones through the 1-1/4 inch BSP(F) outlet port
In effect a relatively small volume of clean water pumped at high pressure is used to move large volumes of mud, sludge and solids
A clever, low-cost tool for home-owners, industry, contractors and hire-centres

The PA SpA tag line is "100% made in Italy"
PA is one of the world's largest manufacturer of pressure washer accessories
The PA quality system is in accordance with the UNI EN ISO 9001:2008 standards
Today PA is based here:
Via Milano, 13
Casella Postale 115
42048 Rubiera (RE)
Italy